Toyobo photopolymer plate 1,52 mm 15 x 21 cm Printight A5, KM152GR, metal backing, 5 pieces

022016

KM152GR, because of the thicker photopolymer layer very suitable for relief printing, typography etc. Steel backing. Thickness of polymer layer 1,52 mm.
Quantity discount applies.

Important:
Polymetaal cuts these A5 plates on a sheet metal shear by cutting A4 size through the middle. Due to the combination of soft polymer on a hard steel backing, the edge of the cutted plate is slightly rounded. It is also possible that the adhesion of the photopolymer layer is not good everywhere. This can not be avoided. If this can be an objection to you, it is better to take A4 format. We can not accept A5 plates with rounded edges being returned to us.

Due to the fragility of the product, it is sold without any warranty. A return shipment is therefore not accepted by us.

The image above is enlarged side view of the KM95R photopolymer plate.
The number 95 refers to the thickness of the polymer layer in mm. The other indications indicate the sort of backing and other properties. The total thickness of the plate is 1,2 mm.
The backing is a thin steel sheet. Dan Welden uses this during the wash-out; in the "wash-tray" he mounted a magnetic plate on the bottom. This "fixes" the plate in the tray during wash out.
In the commercial industry it is handy in order to fix it easily round a cylinder.
Each plate is individually packed in black plastic to avoid unwanted light exposure.

For shipping reasons, extra protective packaging is required:hardboard

Discount: 5 pieces 10%, 20 pieces and more 15%
the discount is calculated automatically.

!
 << 返回  
 
:   kg