Relief Printing (Blockprint) Ink, van Son "Rubber Base Plus" (also for Lithography), oil based The Van Son Rubber Base Plus ink has always been the most used ink on "small offset". It is an economical ink because it can be used on the press for days, without wash-ups. It is not necessary anymore to clean the press every day. The ink will not dry in the pot. Traditional oil based inks will normally dry out on the press within a few hours. The drying of these rubber bae inks also depends upon the paper. Rubber base inks dry through "absorption". If a paper does not absorb ink very well (full-sized paper (internally+surface sized) or coated paper, this ink will never dry well. It is therefore advisable to use waterleaf paper (no sizing) or half sized paper (also known as engine sized, internally sized). |
Van Son stopped production of the Rubberbase inks at the beginning of 2021. These inks were, and are, very popular in letterpress printing techniques such as letterpress, woodcut, linocut, wood engraving and typography. However, Van Son raw materials are still available to make hundreds of cans of Rubberbase printing ink. Unfortunately not in all colors such as black and white. Wifac has been the supplier of Van Son inks in recent years. Wifac will again supply Van Son inks, exclusively for Polymetaal, until the raw materials are exhausted.Some colors are no longer available in Rubberbase. These colors are then supplied from the Epple brand. These are also Pantone colors. |